Epoxy Flooring in Holly Hill, FL

Holly Hill was incorporated in 1901, and its city limits lie entirely on the mainland side of the Halifax River. That gives epoxy flooring in Holly Hill a different starting point than on the beachside. Homes here deal less with blowing beach sand and more with age. The city is small, with 6,907 housing units in the 2020 census, and many of those homes have been lived in by several owners over the decades.

What older Holly Hill floors look like

ACS figures summarized by Point2Homes put the median year built at 1978. About 21.3% of homes were built in the 1940s and 1950s, and another 25.9% in the 1980s. A Holly Hill garage might be: 1. A 1950s carport that was later enclosed, with a step-down and a patched seam between old and new concrete 2. A 1970s or 1980s attached garage with worn sealer, oil stains and a crack or two 3. A detached workshop slab poured by a past owner, sometimes uneven or thin at the edges

We look at which one you have before we suggest a system. Seams and steps need repair and careful edge work. Uneven slabs may need grinding and a self-leveling layer before the coating.

Owners and landlords side by side

Owners hold 53% of occupied homes and renters 47%, per the same ACS summary. About 56.1% of units are single-family detached houses, and there is a mix of duplexes, small apartment buildings and larger complexes. Owners usually ask for a flake garage floor they can keep for years. Landlords ask for something that cleans quickly and hides wear. We price both honestly, and we can keep a rental job simple: one color, one flake blend, done in a day or two.

Get a Free Estimate

Low ground on the river side

Wikipedia lists Holly Hill's elevation at 7 feet, and water makes up about 13.9% of the city's area. Ground water on low, sandy lots can push moisture up through a slab. We test before we quote. A high reading does not rule out a coating, but it changes the primer we use and sometimes the system.

Utility rooms and laundry areas

In many older Holly Hill homes the washer, dryer and water heater sit in the garage or a back utility room. Leaks and drips stain bare concrete and can soften cheap coatings. We use a seamless, chemical-resistant topcoat in those spots and carry the coating a short way up the wall where it helps contain a spill.

Choosing a finish

Most Holly Hill homeowners pick between three options:

• Flake epoxy: the most forgiving look. It hides stains from older slabs and adds texture.
• Solid color with light texture: simple and lower in material cost, good for utility rooms and rentals.
• Polyaspartic topcoat: added over either one where the garage door is open in the sun, so the floor does not yellow.

Workshops and home businesses

Plenty of Holly Hill garages double as workshops for woodworking, small engines or boat repair. Sawdust, solvents and dropped tools are hard on bare concrete. A thicker base coat with a full flake broadcast takes impact better. A chemical-resistant topcoat holds up to the solvents and fuel that end up on the floor. We can also add a painted line or a marked area around a workbench or lift.