Epoxy Flooring in Oak Hill, FL

Epoxy flooring in Oak Hill tends to go into buildings that work. This is a small city of about 2,000 people in southeast Volusia County. Citrus groves and commercial fishing once paid most of the bills here. Freezes and citrus canker cut the groves back, and the state's gillnetting ban by 1995 ended most of the fishing business. Today Wikipedia notes fish, clam and oyster farms in the area. Many lots still have a detached shop or a work building next to the house.

Shop floors first

A shop that handles nets, coolers, pumps, motors or farm gear sees water, salt and heavy loads every week. For these buildings we recommend our commercial and shop floor system:

• Full diamond grinding to remove dirt, oil and old paint
• Repair of cracks, chips and broken control joints
• A thick 100% solids epoxy base coat
• Broadcast quartz or flake for traction where floors get wet
• A hard, chemical-resistant topcoat

We can also slope the work around floor drains, and we leave a clean edge at the door so water runs out instead of under the coating.

A lot of water around a small town

Oak Hill covers about 11.2 square miles, and about 4.5 of that is water. Lagoon air carries salt and moisture inland. Shop buildings with roll-up doors open all day breathe that air. Before each coat we check the dew point against the slab temperature, because a damp surface ruins the bond between coats. On a muggy morning we may close the doors, run fans or wait until the air dries out.

Detached buildings and slab moisture

Outbuildings are often built on simpler slabs than houses, and some have no vapor barrier under them. Moisture rising through that kind of slab is the most common reason coatings blister. We test every floor and use a moisture-tolerant primer when the readings call for it. If the slab is too wet for any coating, we tell you.

Homes and garages

The 2020 census counted 1,185 housing units in Oak Hill and a median age of 58.6. For attached garages we often install a flake floor with a UV-stable polyaspartic topcoat. It gives grip, hides sand and tracked-in grass, and handles the sun through an open door. For lanais and patios, a light, textured outdoor coating stays cooler underfoot.

Caring for a shop floor

Scrape off dried mud and shell grit before it gets ground in. Hose the floor toward the door or drain and squeegee it dry. Wipe up oil, fuel and solvents as soon as you see them. Avoid dragging steel equipment across the floor. Use a cart or plywood instead. If the topcoat wears thin in a high-traffic lane, it can be recoated without redoing the whole floor.

What affects the price

Shop floors are priced by square footage, slab condition and the system chosen. Heavy oil staining, deep cracks and old coatings add prep time. We list every prep step and coat in the written quote so you can see where the cost comes from.

Getting here

Oak Hill sits at the south end of our area, and about 18% of its residents live in areas the census counts as rural. Larger properties mean longer drives between buildings, so when you call, tell us about every surface you are thinking of coating. We can measure the garage, the shop and the porch in one visit and write one quote that breaks each one out.

Call (386) 272-6158 or

Get a Free Estimate

to set up a visit.